Sharing a Meta Quest Screen

How to use a Raspberry Pi to screen cast the output of a Meta Quest 2 Headset.....

micro:bit and sharing sensors with a Raspberry Pi

"Can a Raspberry Pi use the sensors on a micro:bit?" This was the question that was asked whilst sat in the pub the other evening. A few evenings later a micro:bit was connected via i2c to a Raspberry Pi and i2cdetect was ran on the Pi: pi@raspberrypi:

A few notes on I2C and the Picon Zero....

Picon Zero is an Intelligent robotics controller for the Raspberry Pi. A built-in processor handles all the direct communication between the parent controller and any attached devices and motors. Whilst primarily an add on for the Raspberry Pi, due to it using I2C for communications, it is possible to use

Sometimes you just dont have any internet...

A tweet on twitter led me to this discussion on Github. The short version of it is that how could you install the Mu editor onto a fleet of Raspeberry Pi in a school classroom environment where the network can not or will not allow them to connect to the

micro:bit and a Pi with a touch of Python

By now you should be aware of the Mu micropython editor for the micro:bit. Its a self-contained version of the same editor that can be found on the microbit.org However, for use, it needs to be installed onto your system. But how do you use it when your